Warning: You currently have javascript turned off. Functionality of this website will be greatly reduced.

Nationwide Fitting Servicetemplate & fitting available
Fully Fitted or Supply Onlyon all our worktops
Technical Support & Advicecall us on 0345 688 3933
corian worktops

Corian – Sinks/Hob Cutouts

The compulsory method for installing square hobs is the high-strength cutout patented by Dupont™. Hobs must be integrated into a Corian® worksurface, according to specified guidelines.

Where a Corian® splash back or wall cladding is installed a gap of 50mm (minimum) is required behind an electric hob or 150mm (minimum) for a gas hob. A ‘breakfront’ may be necessary to accommodate this requirement. There must be a minimum of 50mm from the cutout to the front of the worktop and a gap of 120mm between cutouts.

A minimum of 50mm is required between two sink cutouts. Sink cutouts must be placed a minimum of 80mm from the worktop front edge.

This is required under terms of the product warranty.

Quote Request Help: Please input the number of linear metres you require (standard 600mm deep worktop). The quick quote calculator will estimate the worktop cost for you. Please contact our sales office if you require a different depth of worktop.

Oops! We could not locate your form.

Sink/Hob Cutout
Belfast Sink (Inc drip groove) Belfast Sink (Inc drip groove)

A minimum of 50mm is required from the cutout to the front edge
A minimum of 120mm is required between heated cutouts.
A minimum of 50mm is required between sink cuouts.