Warning: You currently have javascript turned off. Functionality of this website will be greatly reduced.

Nationwide Fitting Servicetemplate & fitting available
Fully Fitted or Supply Onlyon all our worktops
Technical Support & Advicecall us on 0345 688 3933
Wood Worktops

Wood – Cutouts

Interested in this product? Get a quote
Sink/Hob cutout
Belfast Sink Cutout
AGA/Oven Endcap 20 AGA/Oven Endcap 20
  • Sink cut-outs should be a minimum of 50mm from the worktop front edge.
  • Aluminium foil should be applied to the edges of hob cut-outs.
  • There should be a minimum 200mm between hob cut-outs.
  • Hob cut-outs should be a minimum of 50mm from the worktop front edge.
  • Hob flange needs to sit on the aluminium foil around the cut-out, to avoid conducting too much heat into the wood and causing cracking.
  • When a worktop is to be fitted near to a Aga, Rayburn or similar allow a minimum gap of 4mm. Ideally a solid wood return should be fixed across the end grain to stop any splits occurring.

Drainer Grooves

Drainer Grooves