Warning: You currently have javascript turned off. Functionality of this website will be greatly reduced.

Nationwide Fitting Servicetemplate & fitting available
Fully Fitted or Supply Onlyon all our worktops
Technical Support & Advicecall us on 0345 688 3933
corian worktops

Corian – Sinks/Hob Cutouts

The compulsory method for installing square hobs is the high-strength cutout patented by Dupont™. Hobs must be integrated into a Corian® worksurface, according to specified guidelines.

Where a Corian® splash back or wall cladding is installed a gap of 50mm (minimum) is required behind an electric hob or 150mm (minimum) for a gas hob. A ‘breakfront’ may be necessary to accommodate this requirement. There must be a minimum of 50mm from the cutout to the front of the worktop and a gap of 120mm between cutouts.

A minimum of 50mm is required between two sink cutouts. Sink cutouts must be placed a minimum of 80mm from the worktop front edge.

This is required under terms of the product warranty.

Interested in this product? Get a quote
Sink/Hob Cutout
Belfast Sink (Inc drip groove) Belfast Sink (Inc drip groove)

A minimum of 50mm is required from the cutout to the front edge
A minimum of 120mm is required between heated cutouts.
A minimum of 50mm is required between sink cuouts.